Wednesday, 18 February 2015
12 Ways to Help Your Home Survive Extreme Cold

It is not often that Nashville experiences extreme cold weather for several days in a row, so this year has been quite unusual in that regard.  Everyone is worried not only about staying warm, but the increased energy costs associated with the extreme cold.  Here are some tips that will ensure your home or business remains warm, and keeps your energy bills low, despite the frigid cold temperatures.

  1. Get a tune up.  The best defense against heating problems is to make sure your system is maintained year-round.  Having heating equipment serviced once before the heating season and once before the cooling season can reduce your heating bill and prevent costly repairs, breakdowns, and ensure your system is operating at peak efficiency.
  2. Clean/change the filters.  Dirty air filters reduce your system's efficiency and thus can cause your system to work harder.  Replace air filters regularly a minimum of every 3 months - and do not block air inlets or outlets with furniture or drapes that restrict proper airflow.
  3. Use a humidifier.  During cold weather, increased use of your heater causes the home and its interior air to become dryer than usual.  A humidifier can help add needed moisture, and can also improve health issues like dry sinuses, while saving energy.  Since moist air holds heat, you may feel more comfortable at a lower heat setting.  Be sure you maintain the humidifier properly: clean or replace the filters regularly and wash the base and reservoir.
  4. Resist using the fireplace unless it's an emergency.  Fireplaces can waste a lot of energy, as they pull warm air out of the house and force it out through the chimney.  Make sure the damper is closed when you're not using your fireplace.  Installing glass doors can also help keep heat in your home when the fireplace is not in use.
  5. Use exhaust fans sparingly.  You lose heated air through exhaust fans, so turn them off when not in use during colder weather.  Not only do they pull heated air out of your house, but they can also cause negative pressure inside your home that can lead to back drafts from your fireplace and can cause drafts through the walls, windows and un-insulated outlets in your home.
  6. Prevent the drain line from freezing.  If you have a high efficiency furnace, there is a drain line that runs from the unit to the outside or into some kind of drain.  Know where that line is and make sure it is protected from freezing.  A frozen or plugged up drain line will cause your furnace to shut down.  If it does freeze, thaw it out (use a hair dryer, never an open flame!), turn off the breaker to your furnace, and turn it back on again to reset it.  It should fire back up.  If you see water around your furnace, chances are the drain line is plugged up at some point, and must be cleared.  Check out our previous post about condensate drainage here.
  7. Address non-HVAC-related air flow issues.  Close up any drafts, seal gaps and cracks around windows and doors (good weather-stripping or caulking usually does the trick), replace old windows or install window insulation kits, and look for places where heat may be escaping and/or cold air is rushing in.  Lack of adequate attic insulation is the main reason heating bills can climb sky high, so extra attic insulation is a good investment.
  8. Take advantage of natural heating.  On sunny days, adjust blinds so they are open and tilted toward the ceiling, but be sure to close the blinds at sundown.
  9. Be prepared for power loss.  In extreme cold, the power grid can get overloaded, and winter weather (snow and ice) can bring down tree limbs and cut power lines.  Keep candles, matches, blankets, flashlights, and a battery-powered radio handy.  When utilizing alternate heating sources, such as your fireplace or wood stove, take the necessary safety precautions.  Keep a fire extinguisher handy and test smoke alarms and carbon monoxide (CO) detectors.  Never run the fireplace without first opening the damper!
  10. Give the HVAC unit breathing space.  Do not store anything too close to your indoor HVAC equipment, and definitely do not store anything flammable - paint, paint thinners, rags, glues, gasoline, cleaning solvents, and other chemicals - near your gas furnace or gas water heater.  Not only is it a safety hazard, but HVAC systems need air in order to burn properly and to draft, or carry the harmful by-products of combustion out the flue.  So, remove the clutter.
  11. If you are going away for an extended time, don't switch the heat off!  Leave it on a low setting to ensure nothing freezes.  Water pipes that break from being frozen cause major damage.  Have a neighbor check on your home while you're gone.
  12. Carbon monoxide is deadly.  One of the biggest threats from the cold is carbon monoxide poisoning.  Carbon monoxide is an odorless, colorless gas that can kill quickly if it builds up in a home.  Symptoms are nausea, headaches and disorientation.  Carbon monoxide is produced by heating systems as a by-product of combustion.  Make sure your heating system is properly ventilated.  If you are heating up your car in the garage, make sure the garage door is open and close any access to your home.  If you find yourself stranded in your car, make sure your tailpipe is clear of snow, or the carbon monoxide can flow back into your car.  

Posted on 02/18/2015 7:00 PM by Eddie Hutton
Sunday, 15 February 2015
Are Register & Duct Fans a Solution for Uneven Heating & Cooling?

Are some rooms in your home too warm or too cold?  Does one floor of your house get much warmer or cooler than the other?  Do you find that some vents blow lots of air while others - usually those farthest from the HVAC source - hardly blow much air at all?  No matter how you set your thermostat, does it seem there is always one (or more) room(s) of your house that don't seem to get to the desired temperature? What can be done?

Special fans can help move more of the heated or cooled air already present in the ductwork into the desired room.  Fans on or in the ducts pull this conditioned air into the room, keeping it comfortable longer, so your furnace or air conditioner will run less often, lowering your utility bills.  But do they work?   


Register Fans

Register fans also called in-floor booster fans are small fans that sit directly in or on the register(s) in the problem room(s).  A few kinds are pictured here.  They are easy to install and inexpensive usually less than $80 each. Some come in different colors, have their own thermostat, are multi-speed, or can be electronically controlled.  Most users of register fans find them noisy and prone to frequent failures/burnout.  They can also be a bit cumbersome since they have an electrical cord that needs to be plugged in (wires dangling across the room).  Most of these small fans are akin to the fan inside the typical desktop computer, and they are not rated with a high enough airflow (cfm cubic feet per minute) to really make a difference.  Some believe register fans further restrict airflow because the vent is now blocked by fans.  However, a few folks have found this simple solution helps.  At least it's not too expensive to find out.  


Mid-Duct Fan

A good alternative is installing a mid-duct fan also called an inline duct fan.  This is a large, heavy-duty cylindrical fan, taking up the entire width of the ductwork, e.g., they "replace" a section of ductwork. They are placed mid-way between the HVAC source and your problem room(s).   Your HVAC ducting must be accessible and exposed to install and work on it.  They require an electrical outlet or they can be hardwired, and require a relay back to the furnace.  So, you'll need an electrician or HVAC professional for installation.  Inline duct fans are quieter than register booster fans, and cost $30-$150 each, depending on the size (note: you need to know the size and shape of your existing ductwork so you can pick the right-sized unit!), cfm rating, and features, plus a couple hundred dollars for the electrician.  


Uneven Heating & Cooling

The solutions described above may fix the symptom of uneven heating and cooling, but it is always best to address the root cause of the problem.  Here are some of the typical things that may contribute to airflow problems:

  • clogged air filters,
  • air vents or dampers which are blocked by furniture or not opened fully,
  • return air registers that are blocked, cracks/leaks in windows and doors,
  • a dirty blower wheel and/or coil,
  • leaks in the ducts themselves due to peeling duct tape or holes made by plumbing or rodents. 

If none of the above things is the source of the problem, you might need to address the problem in another fashion.

Often the biggest challenge is the return air - getting the stale air from the second or third floor back down to the furnace to be heated or cooled and redistributed.  In these cases, the best solution is adding returns or installing a thermostatically controlled zone system. 

Having your air duct system professionally balanced might solve the problem and will improve comfort and efficiency.  But if your problem is due to poorly insulated rooms, or undersized ductwork, then no amount of balancing will fix the problem.


The bottom line is that the lack of proper airflow drastically reduces the efficiency of your heating and air conditioning system. Poor airflow decreases system performance, raises utility bills, and reduces equipment life.  It is best to find the root cause of the problem and address it.

Posted on 02/15/2015 8:13 AM by Tony Anderson

Important Tips & Advice



You often don't think about your heating or air-conditioning system until something goes wrong. But there is so much you can do to help keep your system from breaking down. We regularly post information to help you learn what you can do to keep your system running, to save money and energy.  Search our many posts, videos, and podcasts, for valuable information that is never a sales pitch. Subscribe to receive an email when something new is posted, so you won’t miss any important tips.

Choosing a Repair Company

Whether you’re talking about heating or cooling, repairing or replacing a system, you want a company that can advise you reliably based on what is in your best interest, not based on what is convenient or what earns them the most money (commissions). We'll help you choose the best solution to fit your needs. Check out our many posts at HVAC News You Can Use and our podcasts.

Going Green

We're concerned about the environment and know all the latest technologies - such as geothermal systems, LED lights, and smart thermostats - that can reduce energy and put more "green" in your pocket!  We've provided HVAC systems in certified LEED buildings and written many posts on ways to Go Green.

The Sign of Service

We are a repair company performing a full range of commercial and residential heating, air conditioning, energy management and comfort products service, maintenance, and installation. We are a locally-owned company serving Nashville-Davidson County and the surrounding counties including Williamson, Rutherford, Wilson, Sumner, Robertson, and Cheatham.

Who We Are

Our service technicians are fully trained and experienced.  We can tackle the most complicated system to the simplest of systems – from large commercial plants to single-family homes.  Our ownership group of Eddie Hutton, Tony Anderson, Roger Eldridge,  Swaney Powers and Alan Seilbeck have over 125 years combined experience as leaders in the HVAC industry.


We are proud of our dispatchers that respond to your telephone call. When your system is down they make things happen. Our trucks are loaded with most parts needed for a quick repair. You can call day and night 7 days a week. Our normal weekday hours are 7:00AM to 5:00PM. Click on the button below to schedule a service call online. Emails and forms can only be answered weekdays from 7-5.”  

615-832-8500 Online Service Call


Did you know you should service your HVAC on a regular schedule – just like you would your car?  We have specialized maintenance programs to ensure the clean, energy efficient and safe operation of your HVAC systems.  This helps minimize service interruptions/breakdowns and maximize your equipment's lifespan.  All maintenance contract customers are assigned a primary technician that will get to know your facility and equipment and will treat it like his own.  You’ll receive discounts on repairs or new installations, and get priority service when it is cold or hot outside and you need service promptly.  Plus, maintenance contract customers are never charged overtime rates for emergency services after-hours, weekends or holidays. We’ll teach you how to save on maintenance costs by showing you things you can do yourself and when you need a technician. Here are some good posts:  Repair vs. Replace, Things to Try Before Calling for Service, Springtime Tips that Pay Off.


Our team takes on HVAC projects for office, school, retail and industrial facilities. Check out these case studies:

Replacement of a 250-ton Cooling Tower

Ductless HVAC at Brentwood Middle School